7 Series E65 740i (N62TU) SAL
Unfasten screws.
Disengage pressure lines from pipe holders.
Remove pipe holder from front axle carrier.
Installation:
Replace pipe holder.
Make sure pressure lines are laid without tension and with
sufficient spacing to adjoining components.
Tightening torque 37 14 14AZ
.
Release screw of rubber mount for pipes on engine carrier at front
right.
Installation:
Tightening torque 37 14 14AZ
.
Press lower hose holder section downwards.
Installation:
Make sure pressure lines (1, 2) are laid without tension and with
sufficient spacing to adjoining components.
Important!
Risk of damage! Pressure lines must not have any contact
with the stabilizer (minimum distance 5 mm)!
RA Removing and installing/replacing pressure lines for oscillating motor/front axl
BMW AG - TIS
11.02.2013 08:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
