7 Series E65 740i (N62TU) SAL
Open weld joints in areas (1).
Open brazed joints in areas (2).
Installation:
Make a metal angle bracket (1) to protect water drain hose against
welding heat. Length a = 30 mm. Attach metal angle bracket (1)
to hose and secure centrally under cutting edge through welding
spots.
Installation information:
Apply adhesive in areas (1).
Apply window glass adhesive to cavity acoustic baffle (2).
Installation:
Reinforcement of C-pillar latch striker is originally bonded to outer
wheel arch. Drill holes for spot welding in contact area of
reinforcement (1). Adjust side panel to fit and weld holes above
wheel arch.
RA Replacing rear left side panel (partial replacement, longitudinal member cover b
BMW AG - TIS
11.02.2013 08:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
