7 Series E65 740i (N62TU) SAL
Important!
Do not damage door lock seal when removing.
Unclip lock knob control rod (1).
Release screws (2).
Remove door lock from inside (twist out).
Important!
To avoid leakage and electrical malfunction, pull door lock
with special tool 51 2 190 into corner (3), refer to next work
step.
Door lock must be at zero current with Soft Close Automatic
(risk of damage).
Installation:
-
Install door lock and insert screws (1), do not tighten down.
-
Slide special tool 51 2 190 into opened rotary latch until
latch engages in first stage.
Installation:
-
Pretension door lock (1) with knurled screw (2) until special
tool 51 2 190 just contacts corner points (3).
Important!
To tension door lock (1), it is only permitted to turn knurled
screw (2) by a further 1 to 1.5 turns (max.) (risk of
damage).
Door lock seal must be uniformly positioned (water ingress).
-
Tighten down door lock screws (1), tightening torque
51 22 1AZ
.
Installation:
Seal (1) must not be damaged.
Door lock must be replaced if seal (1) is faulty.
RA Removing and installing/replacing door lock in left or right rear door
BMW AG - TIS
11.02.2013 10:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
