7 Series E65 740i (N62TU) SAL
Important!
Observe screw length, use longer screws if necessary.
Correcting contact pattern:
Correction is performed by fitting or removing shims underneath
screws (1 to 3).
-
Remove trim for tail panel at top
-
Release screws (1 to 3)
-
Tilt rear lid lock lower section forwards
-
Carry out correction
-
Check contact pattern again, repeat adjustment if necessary
Tightening torque 51 24 6AZ
.
Open rear lid.
Turn rubber buffers (1) until closed rear lid rests on buffers (1)
on left/right.
Important!
Rear lid must not be higher than set gap dimensions as
otherwise there will be a distortion of height adjustment!
Re-establish plug connection for rear lid lock lower section.
Remove central key (1) from lock cylinder.
Press button (2).
Eccentric pin of rear lid lock lower section turns to top dead
centre.
Close rear lid and check function of Soft Close Automatic, repeat if
necessary.
Add final details to vehicle.
RA Adjusting rear lid lock (lower section of rear lid lock)
BMW AG - TIS
11.02.2013 10:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
