7 Series E65 740i (N62TU) SAL
51 31 241
Replacing rubber frame (top) for rear window
Necessary preliminary tasks:
•
Remove both trim strips from roof frame.
Caution!
Rubber frame (1) has an aluminum section insert (2).
Carefully unwind rubber frame (1) (rear window breakage).
Note:
Tear-off lip (5) can be bonded to adhesive (4).
When rubber frame (1) is removed, tear-off lip (5) may tear off and
remain in vehicle.
3
Rear window
6
Bridge
Installation:
There is no tear-off lip (3) in area (A) on left/right.
Replacement of rubber frame without rear window removal:
Detach tear-off lip (3) from rubber frame (1).
If adhesive above tear-off lip (3) has managed to get onto bridge,
this area must be cut out partially.
To facilitate installation, moisten rubber frame (1) and body cutout
with water.
Replacement of rubber frame with removed or new rear window:
Fit rubber frame (1) with tear-off lip (3).
2
Aluminum strip
RA Replacing rubber frame (top) for rear window
BMW AG - TIS
11.02.2013 11:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
