7 Series E65 740i (N62TU) SAL
51 71 407
Replacing rear spoiler (BMW ALPINA B7)
Removing rear spoiler:
Note:
Tape off rear lid along rear spoiler to avoid paintwork damage.
In area (A), carefully slide plastic wedge between rear lid and
rear spoiler (1) and cut through adhesive bead with a scalpel.
Remove adhesive bead on rear lid down to 0.5 mm.
Minimum object temperature of rear spoiler and body
≥
18
°
C.
If this temperature is not achieved, the components must be
preheated.
Lay rear spoiler on rear lid and mark position with pieces of
adhesive tape.
Remove rear spoiler and treat adhesive area on rear lid with paint
activator.
Fitting rear spoiler:
Sand adhesive area on rear spoiler with P100 abrasive paper.
Clean sanded adhesive area with spirit.
Air drying time at least 1 minute.
Apply adhesive bead dia. = 5 mm at distance (A) to outer edge
of spoiler.
A = 10 ... 15 mm
Leave area (B) open on both sides.
B = 50 mm
Place position ring (1) over BMW badge and secure with
adhesive tape (2).
Note:
The following tasks must be carried out with a 2nd person helping.
-
Place rear spoiler (3) up against position ring (1)
-
Place rear spoiler (3) at sides on rear lid
-
Align rear spoiler (3)
-
Remove position ring
-
Press down rear spoiler (3)
RA Replacing rear spoiler (BMW ALPINA B7)
BMW AG - TIS
11.02.2013 12:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
