7 Series E65 740i (N62TU) SAL
67 62 020
Removing and installing/replacing flat motor
for rear left or right power window regulator
Necessary preliminary tasks:
•
Remove function carrier in rear door
Unlock plug connection (1) and disconnect.
Release screws (2), tightening torque 51 33 1AZ
.
Slacken screw (3) on retaining clip.
Press flat motor for power window (4) towards rear out of
mounting and feed out in direction of arrow.
Installation:
Make sure guides (1) are correctly seated when fitting retaining
clip (2).
Replacement:
Initialize power window.
RA Removing and installing/replacing flat motor for rear left or right power window
BMW AG - TIS
11.02.2013 18:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -