7 Series E65 745d (M67TU) SAL
Replace all conrod bearing shells.
Re-install piston, conrod and bearing shells back in the same
position and in the same installation location.
Connecting rods and bearing covers are designated with the same
pair number: do not mix them.
Important!
Do not scratch cylinder liners.
Attach special tool 11 5 480 to conrod (1).
Attach special tool 11 5 480 to conrod and screw in with
bolt (2).
Align piston ring contact points (1) (offset approx. 120
°
, but not
over piston pin lug).
Note:
Illustration shows N52.
Prepare piston with special tool 11 5 450 and conrod with
special tool 11 5 480 .
RA Removing and installing/replacing all pistons (M67TU)
BMW AG - TIS
12.02.2013 13:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
