7 Series E65 745d (M67TU) SAL
34 41 280
Removing and installing/replacing actuating
unit with control unit for parking brake (PBR)
Important!
With mechanical emergency release of actuating unit, max.
torque at end stop 5 Nm.
After installing actuating unit:
-
Deactivate installation mode status with BMW diagnostic
system.
-
Touch parking brake button three times at intervals of
5 seconds.
-
Carry out brake test on brake analyzer.
•
Drive car with rear axle only onto dynamic brake
analyzer.
•
Engine off.
•
Touch parking brake button and ensure uniform
increase.
Necessary preliminary tasks:
•
Unhook both Bowden cables for parking brake from actuating
unit
•
E67:
Remove starter battery
Observe safety instructions on raising the vehicle.
Unfasten screws.
Installation:
Tightening torque 34 41 3AZ
.
Pull off plug (1).
Remove actuating unit with control unit.
RA Removing and installing/replacing actuating unit with control unit for parking b
BMW AG - TIS
12.02.2013 18:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
