7 Series E65 745d (M67TU) SAL
Pull off liner (3) from adhesive tapes on inside and outside in
approx. 100 mm increments and simultaneously press front
spoiler (1) down on bumper trim (2).
Front spoiler (1) must rest in area (A) without gaps on bumper
trim (2).
Secure front spoiler (1) in adhesive area with clamp/screw clamp
to bumper trim (3).
Note:
Fit protection between clamp/screw clamp and painted surfaces.
Note:
Set down bumper trim without tension.
Allow adhesive to set for 24 hours at min. 15
°
C.
Mechanical strain permitted after no shorter than 2 days (e.g. car
wash).
RA Fitting front spoiler (BMW ALPINA B7)
BMW AG - TIS
12.02.2013 20:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -