7 Series E65 745i (N62) SAL
housing showing the direction of the airflow is pointing towards the control units.
Figure 3
15. Fit the previously removed control units onto the package bracket, front and rear left.
16. Install package bracket, including control units. When doing this, screw the axial fan
bracket including the fan onto the upper securing point of the front left package
bracket.
17. Plug the axial fan onto the connector X2915 on the wiring harness.
18. Bolt the radial fan onto the radial fan bracket. Fix the filter mat into place over the
radial fan air inlet opening with cable ties.
19. Fit the assembled radial fan onto the rear left package bracket and position it in the
boot lid ventilation
(please refer to Fig. 3, left-hand exploded section).
20. Connect the complete radial fan to connector X2914B on the wiring harness and
secure the connector wire to the fan bracket.
21. Secure the control unit cover to the package bracket, front and rear left, with the two
control unit cover clips.
22. Install the telephone control unit
(please refer to Repair Instructions 84 11 620).
23. Secure trims, reinstall removed parts.
Parts:
Description
Part number
Quantity
Package bracket, front left
65 10 6 929 955
1
Package bracket, front right
65 10 6 929 956
1
Boot lid ventilation with split
plates
64 22 4 115 443
1
Seal for
boot lid ventilation
51 71 8 163 653
1
Axial fan bracket
65 12 6 922 804
1
Axial fan
65 12 6 920 409
1
SI Failure of MOST control units at high outside temperatures E65 E66
BMW AG - TIS
14.02.2013 01:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -