7 Series E65 745i (N62) SAL
Note:
If the needle-roller bearings are replaced, the bearing shells must
be replaced as well.
Carefully press bearing shell (1) to one side and simultaneously
remove towards top.
Installation
Installation of eccentric shaft is described separately from
removal.
Note:
Lubricate eccentric shaft at bearing positions.
Replace needle bearing (1).
Important!
Needle bearings break off very easily when installed.
Carefully press needle bearings (1) apart at split position only to
such an extent that they can be fitted over eccentric shaft.
Eccentric shafts from 2/2003:
Note:
Eccentric shafts of cylinders 1 to 4 and 5 to 8 are identical
parts.
Important!
Note installation direction of eccentric shafts.
Depending on the side on which the magnet wheel is fitted,
the eccentric shafts are used for cylinders 1 to 4 or
5 to 8.
Incorrect assembly will result in engine damage.
RA Removing and installing/replacing left eccentric shaft (N62 from 9/03 and N62TU)
BMW AG - TIS
14.02.2013 02:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -