7 Series E65 745i (N62) SAL
Note:
The work steps are only described on one bearing position. The
procedure is identical for the other bearing positions.
Carefully tilt bearing shell (1) to one side and simultaneously
remove towards top.
Lift out eccentric shaft (2).
Removal of magnet wheel (if necessary):
Note:
Carefully clamp eccentric shaft (1) as illustrated with protective
jaws (2) in a vice.
Important!
Danger of mix-up:
It is very easy to mix up left and right or front and rear on the
eccentric shaft.
If necessary, mark the side on which the magnet wheel is fitted.
Note:
Magnet wheel (1) is extremely magnetic.
After removal, place magnet wheel in a plastic bag to protect it
against metal chips.
Release screw and remove magnet wheel (1).
RA Removing and installing/replacing right eccentric shaft (N62 from 9/03 and N62TU
BMW AG - TIS
14.02.2013 03:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -