7 Series E65 745i (N62) SAL
Press linings of centrifugal clutch (1) apart slightly and remove.
Installation:
First position one lining on one side, press apart slightly and then
feed second lining into clutch housing.
Important!
Colour markings (2) must point outwards!
Linings of centrifugal clutch (1) must be pushed into clutch
housing of radial compressor up to stop!
Measure lining thickness (1).
Wear limit is reached at a thickness of 2 mm and then the
linings must be replaced.
Important!
Springs (2) must be inserted into the centre bore (3) of the
linings!
RA Removing and installing/replacing radial compressor centrifugal clutch (BMW ALPI
BMW AG - TIS
14.02.2013 03:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
