7 Series E65 745i (N62) SAL
12 42 500
Removing and installing or replacing battery
positive lead (between alternator, starter
motor and battery positive terminal) (N62)
Work step
Note:
Switch off ignition.
Disconnect negative battery lead.
Follow instructions for disconnecting and
connecting battery.
Remove intake air manifold.
Remove right fresh air duct.
Remove bulkhead, equipment compartment, center.
Remove suction filter housing.
Remove A/C compressor drive belt.
Release battery positive lead at terminal.
Remove check valve on right side (cylinder bank 1 to 4).
Detach battery positive lead from alternator.
Tightening torque, 12 31 1AZ
Lift engine hood into assembly position.
Secure engine in installation position with special tool.
Release both engine mounts from above.
Release grounding strap on engine support arm.
Release A/C compressor and place to one side.
Lower front axle.
Remove right exhaust manifold.
Remove heat shield from starter motor.
Detach battery positive lead from starter motor.
Tightening torque, 12 41 4AZ
Remove battery positive lead.
RA Removing and installing or replacing battery positive lead (between alternator,
BMW AG - TIS
14.02.2013 04:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
