7 Series E65 745i (N62) SAL
13 62 560
Removing and installing/replacing air-mass
flow sensor (N62)
Interrogate fault memory of DME control unit.
Switch off ignition.
Remove upper section of intake filter housing.
Unlock plug (1) and detach.
Release hose clamps.
Pull air-mass flow sensor (2) out of intake hose.
Installation:
Check sealing ring between air-mass flow sensor (2) and
intake hose for damage; replace if necessary.
Installation:
Check sealing ring (1) in upper section (2) of intake filter
housing for damage; replace if necessary.
RA Removing and installing/replacing air-mass flow sensor (N62)
BMW AG - TIS
14.02.2013 07:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -