7 Series E65 745i (N62) SAL
Release screw (1).
Disconnect oil lines (2) from engine oil cooler.
Catch and dispose of escaping oil.
Installation:
•
Tightening torque: 21 Nm.
•
Replace sealing rings.
Unlock and remove retainers.
Installation:
When replacing the radiator, transfer the locating pins for the
retainers over to the new component.
Secure radiator against falling down.
Release screw.
Remove engine oil cooler in downward direction.
Installation:
•
Tightening torque: 14 Nm.
•
Pay attention to bushing between bolt and engine oil cooler.
Important!
Check oil level in engine system.
Refer to Maintenance and General Information, HG00.
RA Removing and installing/replacing engine oil cooler (BMW ALPINA B7)
BMW AG - TIS
14.02.2013 16:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
