7 Series E65 AlpinaB7 (N62) SAL
If necessary, replace plain compression rings (1).
Important!
Plain compression rings (1) can easily break.
Plain compression rings (1) are engaged at joint.
Press compression ring (1) on one side into groove, pull up on
other side and remove catch.
Carefully pull compression ring (1) apart and remove towards
front.
Note:
Inlet camshaft of cylinder bank 5 to 8 is marked with "EIN 58".
If necessary, replace sensor gear (1).
Release screw (2) and remove sensor gear (1).
Installation:
Installation of inlet camshaft is described separately from removal.
Clean all bearings and cams of inlet camshaft and lubricate with
engine oil.
Note:
Camshaft has a groove and sensor gear has a lug for fastening
purposes.
RA Removing and installing/replacing left inlet camshaft (N62 from 9/03 and N62TU)
BMW AG - TIS
20.02.2013 04:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -