7 Series E65 AlpinaB7 (N62) SAL
Place special tool 11 9 461 on inlet camshaft and check timing.
Note:
The timing is correctly adjusted when special tool 11 9 461
rests flat on the cylinder head or protrudes by up to 0.5 mm to
the exhaust side.
Place special tool 11 9 462 on exhaust camshaft and check
timing.
Note:
The timing is correctly adjusted when special tool 11 9 462
rests flat on the cylinder head or protrudes by up to 0.5 mm to
the exhaust side.
Remove all special tools.
Important!
Screw (1) is a special screw and must not be replaced with a
normal M8 screw.
Clip oil line (3) into retainers (2).
Insert screw (1) and tighten down.
Assemble engine.
RA Removing and installing/replacing inlet and exhaust adjustment units on right si
BMW AG - TIS
20.02.2013 04:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -