7 Series E65 AlpinaB7 (N62) SAL
13 54 ...
Removing and installing/replacing charge-air
pressure actuator (BMW ALPINA B7)
Necessary preliminary tasks:
•
Remove clean air pipe
Important!
When working on charge-air pressure actuator:
-
Switch off ignition
-
Do not switch on ignition when charge-air pressure
actuator is disconnected (engine limp-home program)
After completing work:
-
Clear fault memory
Disconnect plug connection (1).
Release bolts (1) and remove charge-air pressure actuator (2).
Installation:
Replace seal.
Tightening torque: 9 Nm.
RA Removing and installing/replacing charge-air pressure actuator (BMW ALPINA B7)
BMW AG - TIS
20.02.2013 05:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
