7 Series E65 AlpinaB7 (N62) SAL
Remove stabilizer link from swinging arm.
Remove spring strut shock absorber/air spring strut from wheel
carrier.
Raise wheel carrier for feeding output shaft out and in with
workshop jack approx. 20 mm.
Important!
Risk of damage!
Do not drive output shaft out of drive flange with an impact
tool.
Press output shaft out of drive flange and remove towards centre
of vehicle.
After installation:
•
Check that output shaft is correctly seated in rear differential.
•
Version with ride-height control: Activate and fill air
suspension system
RA Removing and installing / replacing right output shaft
BMW AG - TIS
20.02.2013 08:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
