7 Series E65 AlpinaB7 (N62) SAL
Remove pipe holder from underbody of vehicle.
Installation:
Replace pipe holder.
Make sure pressure lines are laid without tension and with
sufficient spacing to adjoining components.
Tightening torque 37 14 14AZ
.
Release nuts at junction II.
Tightening torque 37 14 13AZ
.
Remove pipe holder (1) from tension strut.
Installation:
Make sure pressure lines are laid without tension and with
sufficient spacing to adjoining components.
Tightening torque 37 14 14AZ
.
Release nuts at junction III.
Disconnect pressure lines (1, 2).
Installation:
Make sure pressure lines are laid without tension and with
sufficient spacing to adjoining components.
Tightening torque 37 14 13AZ
.
Remove right output shaft.
Remove complete rear axle carrier.
RA Removing and installing/replacing pressure line for oscillating motor/rear axle
BMW AG - TIS
20.02.2013 10:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -