7 Series E65 AlpinaB7 (N62) SAL
Four pins must be unpinned from the plug, insulated and tied back
to the wiring harness:
•
Pin 9
•
Pin 10
•
Pin 21
•
Pin 22
Read and comply with notes on opening and unpinning.
After installation:
•
Replacement only: Carry out programming/coding
•
Only when replacing / programming / coding: Carry out
steering angle sensor adjustment
•
Only when replacing / programming / coding: Carry out initial
DYNAMIC DRIVE operation.
RA Removing and installing/replacing DYNAMIC DRIVE control unit
BMW AG - TIS
20.02.2013 10:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -