7 Series E65 AlpinaB7 (N62) SAL
Measurement b = approx. 200 mm from lower latch striker screwing point.
Open weld joints in areas (1).
Installation information:
-
Apply window glass adhesive to cavity acoustic baffle (2).
-
Weld in reinforcing plates approx. 30 mm long at severance cuts.
Open weld joints in areas (1).
Open brazed joints in areas (2).
Installation:
Make a metal angle bracket (1) to protect water drain hose against
welding heat. Length a = 30 mm. Attach metal angle bracket (1)
to hose and secure centrally under cutting edge through welding
spots.
Installation:
Reinforcement of C-pillar latch striker is originally bonded to outer
wheel arch. Drill holes for spot welding in contact area of
reinforcement (1). Adjust side panel to fit and weld holes above
wheel arch.
RA Replacing rear left side panel (partial replacement before longitudinal member c
BMW AG - TIS
20.02.2013 11:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -