7 Series E66 730Li (M54) SAL
22 32 001
Replacing rubber mount for transmission
mounting
Necessary preliminary tasks:
-
Remove complete exhaust system
-
Remove heat shield at rear.
-
Remove heat shield at front
-
Remove transmission underbody panelling
-
Observe safety instructions on raising the vehicle
Release crash pin.
Installation:
Tightening torque 22 32 1AZ
.
When fitting a new cross-member, the crash pin must also be
replaced.
Screw head of crash pin must rest on transmission cross-member.
Unscrew nuts (2).
Release both rubber mount nuts on transmission.
Release screws (1) and remove transmission cross-member.
RA Replacing rubber mount for transmission mounting
BMW AG - TIS
04.02.2013 22:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -