7 Series E66 730Li (M54) SAL
26 11 000
Removing and installing complete propeller
shaft
Necessary preliminary tasks:
•
Remove exhaust system.
•
Remove heat shields and transmission underbody protection.
•
Support transmission from underneath.
•
Remove transmission cross-member.
Unfasten screws.
Note:
To facilitate release of propeller shaft screw connection, manually
unlock transmission lock.
Installation:
Replace self-locking nuts.
Important!
All except N62 /M67:
The screw without washer may only be tightened by means of
the nut.
The screw with rolled-on washer which has ribbed teeth facing
the support side must be tightened by means of the screw.
Observe different tightening torques.
Tightening torque: 26 11 1AZ
.
Unscrew nuts.
Installation:
Tightening torque: 26 11 4AZ
.
RA Removing and installing complete propeller shaft
BMW AG - TIS
04.02.2013 22:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -