7 Series E66 730Li (M54) SAL
Position coil spring on spring strut and turn until end of spring
contacts stop of spring pad (arrow).
Warning!
Do not compress coil spring to full extent.
Upper coil of coil spring must rest completely in recess of
special tool 31 3 382 !
Tension coil spring.
Attach spring plate with bearing and spring pad to piston rod.
Check support bearing for damage, replace if necessary.
Attach support bearing and joint seat to piston rod.
Replace nut and tighten down (gripping piston rod in so doing).
Tightening torque 31 31 2AZ
.
Important!
Upper coil of coil spring must rest positively on spring plate!
Lower end of coil spring must rest on stop of spring pad!
Relieve tension on coil spring.
Check installation position of gaiter, correct fold if necessary.
After installation:
•
Carry out wheel alignment check if a spring strut with support
bearing was or has been installed without centering pin.
RA Replacing front left or right spring strut (sport suspension)
BMW AG - TIS
04.02.2013 23:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
