7 Series E66 730Li (M54) SAL
Important!
1.
Prior to each use, check the special tools for defects,
modifications and operational reliability.
2.
Damaged/modified special tools must not be used!
3.
No changes or modifications may be made to the special
tools!
4.
These special tools are intended solely for the purpose
of tightening and relieving cylindrical and tapered
suspension springs.
5.
Keep special tools dry, clean and (down to the spindle)
free from grease.
6.
Impact screwdrivers are prohibited!
7.
Do not compress coil spring to full extent.
Necessary preliminary tasks:
•
Remove front spring strut
Release nut and remove holder for brake hose, pulse generator
and if necessary brake pad sensor.
Remove screw towards front.
Expand swivel bearing with special tool 31 2 200 .
Pull spring strut out of swivel bearing.
Installation:
Keep press fit of swivel gearing and spring strut in lower area
clean and free from oil and grease.
Spread swivel bearing with special tool 31 2 200 , align by
means of gap to web on back of spring strut and push together as
far as it will go.
Replace self-locking nut.
Tightening torque 31 31 3AZ
.
RA Replacing front left or right spring strut (standard suspension, build date from
BMW AG - TIS
04.02.2013 23:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
