7 Series E66 730Li (M54) SAL
33 31 000
Removing and installing complete rear axle
carrier
Special tools required:
•
00 2 040
•
33 3 274
•
33 4 227
•
33 4 228
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off pipe connections with plugs.
Necessary preliminary tasks:
•
Version with ride-height control: Deactivate and drain air
spring system
•
Remove brake disc on both sides
•
Disconnect parking brake Bowden cable on both sides from
expander lock
•
Remove propeller shaft from rear differential and tie back or
remove completely if necessary
•
Remove hose from fuel filler pipe and seal
•
Detach plug connection for pulse generator on both sides
and expose line up to control arm
•
Detach plug connection for brake pad wear sensor on right
and expose line up to control arm
•
If necessary, disconnect plug connections at ride-height
sensors
•
Remove spring strut shock absorber/air spring strut on both
sides from wheel carrier
RA Removing and installing complete rear axle carrier
BMW AG - TIS
05.02.2013 00:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -