7 Series E66 730Li (M54) SAL
33 32 071
Replacing one upper control arm
Important!
Observe safety instructions on raising the vehicle.
Note:
If the control arm is detached from the rear axle carrier, it is
necessary after reinstallation to carry out a wheel/chassis
alignment check.
Necessary preliminary tasks:
•
Remove rear wheel
Release nut (1) and remove bolt (2) towards front.
Installation:
Replace self-locking nut.
Tighten bolt connection in normal position.
Tightening torque 33 32 14AZ
.
Remove holders (1) from control arm.
Release nut; if necessary, grip at external hexagon/Torx socket.
Take off control arm.
Installation:
Keep control arm to wheel carrier connection clean and free from
oil and grease.
Replace self-locking nut.
Tightening torque 33 32 8AZ
.
RA Replacing one upper control arm
BMW AG - TIS
05.02.2013 00:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
