7 Series E66 730Li (M54) SAL
37 10 005
Removing and installing / replacing vent hose
(from 06 / 2003) for active stabilizer (front)
Necessary preliminary tasks:
•
Remove front assembly underside protection
Release banjo bolts (2) and remove vent hose (3).
Tightening torque 37 11 2AZ
.
Disconnect vent hose (3) from Y-distributor.
Unscrew vent valves (1) from oscillating motor.
Installation:
If necessary, fit new vent valves (see note at end of document).
Tightening torque 37 11 1AZ
.
Unclip cover (1) and pull filter out of front axle carrier.
Expose vent hose (2) up to Y-distributor and remove.
Replacing vent valve:
Screw vent valve (1) fully into oscillating motor and remove plug.
Slide vent hose (2) into vent valve (1) up to second
marking (M).
RA Removing and installing / replacing vent hose (from 06 / 2003) for active stabil
BMW AG - TIS
05.02.2013 01:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -