7 Series E66 730Li (M54) SAL
37 20 001
Removing and installing/replacing DYNAMIC
DRIVE valve block
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off pipe connections with plugs.
Note:
In a warranty case you must always provide a fault memory
printout, even where there is no fault memory entry, with the
defective part.
Necessary preliminary tasks:
•
Draw off and dispose off hydraulic fluid from fluid reservoir
•
Remove bottom right wheel arch trim
•
Partially remove right underbody panelling
Release nuts (1, 2) (pressure lines to rear axle oscillating motor).
Tightening torque 37 14 12AZ
.
Release nut (3) (return line)
Tightening torque 37 14 19AZ
.
Release nut (4) (pressure line)
Tightening torque 37 14 16AZ
.
Release nuts (5, 6) (pressure lines to front axle oscillating motor).
Tightening torque 37 14 15AZ
.
Installation:
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
RA Removing and installing/replacing DYNAMIC DRIVE valve block
BMW AG - TIS
05.02.2013 01:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
