7 Series E66 730Li (M54) SAL
41 11 300
Replacing cover for longitudinal member with
left or right door pillar (partial replacement B-
pillar, rear side panel removed)
Read contents of Body, General.
Spot-weld bonding is used for the first time on the E65. A
specific procedure must be followed here.
Place vehicle on straightening bench.
Following new body parts are required (refer to EPC):
-
(1) B-pillar with entrance
-
(2) Attachment, entrance, outer
Mark severance cuts in accordance with specified measurements and cut.
Caution!
Cut outer plate only for following severance cuts.
Measurement a = approx. 100 mm in front of bore dia. 6 mm.
RA Replacing cover for longitudinal member with left or right door pillar (partial
BMW AG - TIS
05.02.2013 01:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
