7 Series E66 730Li (M54) SAL
51 13 082
Replacing trim grille for heater air inlet
Necessary preliminary tasks:
•
Remove trim grille for heater air inlet
Sever holders (1) on trim grille (2) until flush.
Place lower section (2) on trim grille (1).
Press on lock washers (4) with a TORX E4 socket (5).
Shorten all plastic pins (3) down to measurement (A).
A = 2 mm
Important!
Measurement (A) for centre plastic pin in direction of travel at
front must only be 1 mm (risk of damage).
RA Replacing trim grille for heater air inlet
BMW AG - TIS
05.02.2013 02:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
