7 Series E66 730Li (M54) SAL
Open cable holders (1).
Feed out hydraulic hoses (2).
Open cable holder (1) and feed out hydraulic hoses (2).
Lever hydraulic cylinder (4) out of ball pin (3).
Release retainer (5), remove and detach hydraulic cylinder (4)
from rear lid hinge (6).
Hoses on hydraulic cylinder must be sealed tight. For this
purpose, use the seal plugs and cap nuts from the "Small parts for
hydraulic cylinder" set.
Important!
Hose connections (2) on hydraulic cylinder (1) must not be
twisted.
Installation:
Check function.
RA Removing and installing/replacing hydraulic cylinder for rear lid (electrohydrau
BMW AG - TIS
05.02.2013 03:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -