7 Series E66 730Li (M54) SAL
61 61 270
Removing and installing complete wiper
console
Remove cowl panel cover from windshield.
Remove left fresh air duct.
Unlock plug (1) and detach.
Release screws.
Remove wiper bracket (2).
Installation:
Wiper bracket (1) must rest by its own weight flat on all mounting
points (2).
Installation:
Install screws in sequence 1 to 3 and tighten hand-tight.
You should be able to install all screws without having to exert
effort or twisting the wiper bracket. If the tolerance compensation
in the sleeves is insufficient or the wiper bracket does not rest flat
by its own weight alone on all the mounting points, the wiper
bracket and the body must be immediately aligned (refer to next
work step).
Tighten down screws in sequence 1 to 3.
Tightening torque, 61 61 6AZ .
RA Removing and installing complete wiper console
BMW AG - TIS
05.02.2013 22:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
