7 Series E66 730Li (M54) SAL
72 12 000
Removing and installing/replacing airbag
module on passenger side
Warning!
Observe safety regulations for handling airbag modules and
pyrotechnical seatbelt tensioners.
Incorrect handling can activate airbag and cause injury.
Follow instructions for disconnecting and connecting battery!
Disconnect battery negative lead.
Remove glovebox.
Version with CD changer:
Remove CD changer.
Unfasten plug connection (3) and disconnect.
Release screws (4).
Lay retaining clip (2) slightly to one side.
Important!
Airbag module (1) could fall out after screws (5) have been
released. Grip airbag module (1).
Release screws (5) and carefully remove airbag module (1).
Installation:
When inserting airbag module (4) in channel (3), make sure
channel (3) rests all round airbag module (4). If necessary, pull
channel (3) apart at sides.
Replace screws (1).
Retainers (2) fall out during removal and do not have to be
replaced.
Tightening torque 72 12 02AZ
.
RA Removing and installing/replacing airbag module on passenger side
BMW AG - TIS
06.02.2013 01:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
