7 Series E66 730Li (N52) SAL
33 55 021
Replacing both rubber mounts for stabilizer
mounting
Important!
Observe safety instructions on raising the vehicle.
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off pipe connections with plugs.
After installation:
•
Version with ride-height control: Activate and fill air
suspension system
•
Version with Dynamic Drive:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
Carry out initial Dynamic Drive operation
•
Adjusting parking brake
Necessary preliminary tasks:
•
Remove complete rear axle carrier
Release screws (1) on both sides.
Tightening torque 33 55 3AZ
.
Remove retaining bracket (2) on both sides.
Remove rubber mount (3) on both sides.
Installation:
Keep retaining bracket (2), rubber mount (3) and stabilizer clean
and free from oil and grease.
Version with Dynamic Drive: Keep contact face for rubber mount
on anti-friction bearing clean and free from oil and grease.
RA Replacing both rubber mounts for stabilizer mounting
BMW AG - TIS
07.02.2013 02:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -