7 Series E66 730Li (N52) SAL
34 52 550
Removing and installing/replacing DSC yaw
sensor (DSC sensor)
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Remove right front seat
•
Remove front inside entrance cover strip
Note:
The yaw sensor comprises the function of the transversal-
acceleration sensor and the yaw sensor.
Important!
Do not kink floor panelling under any circumstances!
Lift floor carpet and fold back to one side.
Remove expansion rivets (1).
Carefully raise air duct at rear and turn to one side.
Disconnect plug connection.
Release screws (1) and remove rotation rate sensor.
Installation:
Tightening torque, 34 51 3AZ.
Ensure proper locking of plug connector.
RA Removing and installing/replacing DSC yaw sensor (DSC sensor)
BMW AG - TIS
07.02.2013 03:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
