7 Series E66 730Li (N52) SAL
37 13 100
Removing and installing/replacing pressure
lines for oscillating motor/front axle
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off pipe connections with plugs.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
If necessary, carry out initial operation for Dynamic Drive
Necessary preliminary tasks:
•
Lower front axle support
Release nuts on valve block.
Tightening torque 37 14 15AZ
.
Release nuts at junction I.
Tightening torque 37 14 13AZ
.
Disconnect pressure lines (1, 2).
Installation:
Pressure lines are protected against being mixed up by different
thread diameters on the valve block connection.
Make sure pressure lines are laid without tension and with
sufficient spacing to adjoining components.
RA Removing and installing/replacing pressure lines for oscillating motor/front axl
BMW AG - TIS
07.02.2013 03:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -