7 Series E66 730Li (N52) SAL
Release screws (1).
Tightening torque 31 14 14AZ
.
Remove pipe holder (2) from rear axle carrier.
Installation:
Replace pipe holder (2).
Make sure pressure lines are laid without tension and with
sufficient spacing to adjoining components.
Tightening torque 31 14 14AZ
.
Important!
Risk of damage! Pressure lines must not have any contact
with the stabilizer (minimum distance 5 mm)!
Release nuts on oscillating motor.
Remove pressure lines from oscillating motor.
Installation:
Pressure lines are protected against being mixed up by different
thread diameters on the oscillating motor connection.
Tightening torque 31 14 18AZ
.
RA Removing and installing/replacing pressure line for oscillating motor/rear axle
BMW AG - TIS
07.02.2013 03:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
