7 Series E66 730Li (N52) SAL
Checking fluid level in hydraulic unit:
Necessary preliminary tasks:
•
Remove right luggage compartment wheel arch trim
E67 only:
•
Remove additional trim panel
Test requirements:
Open rear lid (motor-driven) twice and close again, this bleeds the
system.
Rising air bubbles must not be visible.
Check fluid level in installed state.
Check distance (B) from middle of marking (3) to upper edge of
pump carrier (1).
B = 28
±
1 mm
When rear lid is fully opened (cylinder retracted), fluid level (2)
must be in area (A) of marking (3).
Note:
Fluid fill quantity (lines filled with fluid and cylinder retracted):
-
Top edge of marked cross = 100 ml
-
Bottom edge of marked cross = 80 ml
Correcting fluid level in hydraulic unit:
Operation is described in:
•
Correct fluid level in hydraulic unit for rear lid actuation
(electrohydraulic-fully automatic).
RA Notes and instructions on automatic rear lid actuation (from 02/2003) (electrohy
BMW AG - TIS
07.02.2013 17:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -