7 Series E66 730Li (N52) SAL
Release screws (1).
Installation:
Tightening torque 51 42 1AZ
.
Note:
Start unclipping at bottom.
Unclip clips (2) of door trim with special tool 00 9 317 .
Carefully unclip door trim panel (1) at top from retainers (2).
Feed out door trim (1) from unlocking knob (3).
Unhook Bowden cable for release lever:
-
Tighten release lever (1).
-
Lever out lock (2).
-
Detach Bowden cable (3) towards rear/top.
Installation:
For fitting, press release lever (1) fully onto door trim panel.
Model with side airbag:
Warning!
Disconnect plug connection on side airbag.
RA Removing and installing left or right rear door trim panel
BMW AG - TIS
07.02.2013 18:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
