7 Series E66 730Li (N52) SAL
66 31 006
Removing and installing/replacing ACC
sensor (build date up to 03/2005)
After installation:
-
Adjusting ACC sensor
-
Carry out programming/coding
Note:
Engine hood is open.
Unclip electric cable (1) from cable guides.
Unfasten screws (2).
Lever out ACC sensor (3) in direction of arrow and disconnect
plug connection underneath.
Remove ACC sensor (3).
Installation:
Make sure both guide pins (1) of ACC sensor (2) are correctly
seated.
Replacement only:
Carry out rough adjustment of ACC sensor (1) at adjusting
screws (2).
•
Measurement A [mm]: 6.35
±
0.2
•
Measurement B [mm]: 4.85
±
0.2
RA Removing and installing/replacing ACC sensor (build date up to 03/2005)
BMW AG - TIS
08.02.2013 00:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -