7 Series E66 730Li (N52) SAL
Lever drive unit for longitudinal seat adjustment (1) with rubber
grommet (2) upwards out of guide (3).
Disconnect both drive shafts (4) from drive unit for longitudinal
seat adjustment (1).
Installation:
Make sure rubber grommet (2) is correctly seated in guide (3).
Make sure both drive shafts (4) are correctly seated.
Build date from 03/2003:
Disconnect plug connections (1).
Release expander rivets (2), replace if necessary.
Important!
Do not kink drive shafts (4).
Raise flange (1) with drive unit for longitudinal seat
adjustment (2) slightly and detach from left drive shaft.
Feed out drive unit for longitudinal seat adjustment (2) in
direction of arrow and detach from right drive shaft.
Note:
To facilitate installation/removal, lever out guide clip (3) if
necessary.
Installation:
Make sure guide clips (3) and both drive shafts (4) are correctly
seated.
Comfort seat, all build dates:
Replacement:
Initialize drive unit for longitudinal seat adjustment.
RA Removing and installing/replacing drive unit for longitudinal seat adjustment
BMW AG - TIS
08.02.2013 00:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
