7 Series E66 740Li (N62TU) SAL
Note:
When tightening down screw (2), grip camshaft at hexagon head.
Tighten down screw (2) of exhaust adjustment unit.
Tightening torque 11 36 16AZ .
Release screw (1) and remove special tools 11 9 463 /
11 9 462 from exhaust camshaft.
Remove special tool 11 9 190 .
Crank engine at central bolt twice in direction of rotation until
engine returns to firing TDC position of 1st cylinder.
Secure vibration damper with special tool 11 9 190 in firing
TDC position of 1st cylinder.
Place special tool 11 9 461 on inlet camshaft and check timing.
Note:
The timing is correctly adjusted when special tool 11 9 461
rests flat on the cylinder head or protrudes by up to 0.5 mm to
the exhaust side.
Remove special tool 11 9 461 from inlet camshaft.
RA Removing and installing/replacing inlet and exhaust adjustment units on left sid
BMW AG - TIS
10.02.2013 01:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -