7 Series E66 745Li (N62) SAL
Unlock plug on DISA servomotor and disconnect.
Release negative lead on spring strut dome.
Unlock plug connections in electronics box and disconnect:
·
at DME control unit
·
at Valvetronic control unit
·
at supply module
·
Remove electronics box
cover.
·
Do not remove control
units
Installation:
Make sure profile seals are
correctly positioned.
Installation:
Read out fault memory of control unit of Digital Motor Electronics
(DME).
Check stored fault messages.
Rectify faults.
Now clear the fault memory.
RA Replacing wiring harness section for engine (N62)
BMW AG - TIS
11.02.2013 07:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -