7 Series E66 745Li (N62) SAL
-
Detach water drain hoses (4)
-
Unlock and disconnect plug (2)
-
Disconnect cable (5) from glass slide/tilt sunroof (6)
-
Release screws (1) (during installation: fit shims)
Tightening torque 54 12 6AZ
.
-
Release screws (3) on left/right and carefully lower glass slide/tilt sunroof (6)
Tightening torque 54 12 6AZ
.
Important!
Do not damage any surrounding parts when removing glass slide/tilt sunroof (6).
-
Remove glass slide/tilt sunroof (6) completely (through rear door)
Installation:
Due to robot assembly, all screws (1) are secured with
washers (2) in production. These washers (2) are not absolutely
necessary during manual assembly. They are however useful for
positioning the frame on the body with 4 screws.
If the standard screws can no longer grip, use "repair screws"
(have larger threads).
Important!
Do not crush any cables when fitting the glass slide/tilt
sunroof.
RA Removing and installing complete glass slide/tilt sunroof (frame)
BMW AG - TIS
11.02.2013 16:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -