7 Series E66 750Li (N62TU) SAL
31 11 001
Replacing front axle carrier
Warning!
Danger to life!
Secure engine in installation position to prevent it from falling
down.
Important!
Observe safety instructions on raising the vehicle.
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off hydraulic lines with plugs.
Necessary preliminary tasks:
•
Secure engine in installation position
•
Disconnect battery negative lead
•
Draw off and dispose off hydraulic fluid from fluid reservoir
•
Remove front wheels
•
Remove stabilizer
•
If necessary, remove rear assembly underside protection
•
Remove air duct for brake ventilation on both sides
•
Remove reinforcement plate
•
If necessary, remove steering gear cover on both sides
•
Remove universal joint from power steering gear
•
Disconnect plug connection on Servotronic converter
•
Disconnect plug connection from ride-height sensor
•
If necessary, disconnect vacuum line from electrically
operated valve to engine mounts at T-piece
•
Remove pressure line and if necessary Dynamic Drive
pressure line from vane pump
•
Disconnect return line from power steering cooler
•
Remove tension strut on both sides from front axle carrier
•
Remove control arm on both sides from front axle carrier
•
Remove tie rod end on both sides from swivel bearing
RA Replacing front axle carrier
BMW AG - TIS
12.02.2013 15:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
