7 Series E66 750Li (N62TU) SAL
41 14 502
Replacing rear left outer wheel arch section
(rear left side panel removed)
Read contents of Body, General.
Spot-weld bonding is used for the first time on the E65. A
specific procedure must be followed here.
Following new body parts are required (refer to EPC):
-
(1) Wheel arch, outer, rear
-
(2) Reinforcement, C-pillar, inner
Mark severance cut on inner C-pillar reinforcement in accordance
with measurement a and cut.
Measurement a = approx. 150 mm from roof edge.
Open weld joints in areas (1).
Remove inner C-pillar reinforcement.
Mark severance cut (1) on outer wheel arch in accordance with
illustration and cut.
RA Replacing rear left outer wheel arch section (rear left side panel removed)
BMW AG - TIS
12.02.2013 19:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -